Serial Ports; Program No - Furuno GP-7000 Operator's Manual

10. MAINTENANCE & TROUBLESHOOTING
10.5.4

Serial ports

You can confirm the signal input.
1. Rotate the [ENTER] knob to choose Serial port from the SYSTEM TEST.
2. Push the [ENTER] knob to show the Serial port window.
3. Rotate the [ENTER] knob to choose "Change parameters" and then push the
[ENTER] knob.
4. Enter the settings for the port in use and then push the [CLEAR] key.
5. Rotate the [ENTER] knob to choose "Input data display" and then push the
[ENTER] knob.
6. Press the [CLEAR] key twice to finish.
Note: When choosing Input data display, the data input from the external
equipment connected are shown.
10.6

Program No.

You can confirm the software program No by following procedure.
1. Rotate the [ENTER] knob to choose "ADVANCED", and then push the
[ENTER] knob.
2. Rotate the [ENTER] knob to choose "SYSTEM UPDATE", and then push the
[ENTER] knob to show the System update menu..
3. To escape from the System update menu, press the [MENU] key.
10-6
Change parameters
Input data display
Serial port
Port:
Baud Rate: 4800
Data Bits:
Parity:
Stop Bits:
System Update
Plotter SW version:
SW Development No:
Kernel:
NTSL:
BIOS:
File System:
Worldwide Charts
GPS:
Update Plotter Software
Update Worldwide Maps
PORT2
8
none
1
1451721-**.**
10.06.***
1.03.***
6.01.***
1.02.***
3.00.***
*.**
485026****
*: Program version No.