Perform 30 Day Service; Check The Track Tension And Fastener Torque; Trax And S-65 Trax - Terex Genie S-60 Service Manual

Service Manual
Checklist A Procedures
A-10 A-10 Perform 30 D ay Service
Perform 30-Day Service
The 30-day maintenance procedure is a onetime
procedure to be performed after the first 30 days or
40 hours of usage. After this interval, refer to the
maintenance tables for continued scheduled
maintenance.
1 Perform the following maintenance
procedures:
• A-13
Grease the Turntable Rotation
Bearing and Rotate Gear
• B-6
Inspect the Tires, Wheels and Lug
Nut Torque, S-60, S-65, S-60 HC, S-60X
and S-60XC
• B-8
Check the Drive Hub Oil Level and
Fastener Torque
• D-2
Check the Turntable Rotation
Bearing Bolts
• D-6
Replace the Hydraulic Filters
S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC
32
A-11 A-11 C hec k the Trac k T ensi on and F astener T orque, S-60 TR AX and S-65 TR AX
Check the Track Tension and
Fastener Torque, S-60 TRAX and
S-65 TRAX
Manufacturer specifications require that this
procedure be performed every 30 days.
Maintaining proper track tension and properly
torqued fasteners is essential to good machine
performance and service life. The machine will not
operate properly with a track that is incorrectly
tensioned. Continued use of a machine with
incorrectly tensioned tracks may cause component
damage.
1 Thoroughly clean the track assembly of any
dirt, rocks, clay, etc.
2 Chock the tracks at one end of the machine to
prevent the machine from rolling.
3 Center a lifting jack of ample capacity
(20,000 lbs / 10,000 kg) under the drive
chassis between the tracks at the other end of
the machine.
4 Lift the machine until the tracks are off the
ground and then place jack stands under the
drive chassis for support.
February 2015
Part No. 825591