Replace The Hydraulic Filters - Terex Genie S-60 Service Manual

Service Manual
Checklist D Procedures
12 Re-engage the drive hubs by turning over the
hub disconnect caps. Rotate each wheel or
track to check for engagement. Raise the
machine, remove the jack stands and lower
the machine.
Collision hazard. Failure to
re-engage the drive hubs could
result in death or serious injury
and property damage.
1 brake disengaged position
2 brake engaged position
S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC
78
D-6 D-6 Repl ace the Hydr aulic Filters

Replace the Hydraulic Filters

Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Perform this procedure more often if dusty
conditions exist.
Replacement of the hydraulic filters is essential for
good machine performance and service life. A dirty
or clogged filter may cause the machine to perform
poorly and continued use may cause component
damage. Extremely dirty conditions may require
that the filter be replaced more often.
Bodily injury hazard. Beware of
hot oil. Contact with hot oil may
cause severe burns.
Note: Perform this procedure with the engine off.
Hydraulic return filter
1 Open the ground controls side turntable cover
and locate the hydraulic return filter housing
on top of the hydraulic tank.
2 Remove the cap from the filter housing.
3 Lift the handle on the filter element and rotate
the element counterclockwise to release the
element from the housing.
4 Remove the filter element from the housing.
5 Install the new filter element into the filter
housing.
6 Push the filter element down to be sure the
O-ring on the element is fully seated into the
housing.
February 2015
Part No. 825591