Setting The Metronome Function - Fostex VF160EX Operation Manual

Correction of the Registered Tempo
1. Under the above "Confirmation display," select the tempo
map which is to be changed and press the [ENTER/YES]
key.
The same as before, "tempo value" will flash.
2. Input the desired tempo with the [JOG] dial and press
the [ENTER/YES] key.
3. Upon completing registering, press the [EXIT/NO] key
(or [STOP] key) to exit from the SETUP mode.
"Setting the Metronome function" menu allows you to determine whether or not the VF160EX outputs a metronome
sound from track 16 during playback or recording. Turning the Metronome function on enables you to record your
performance while playing the instrument accompanying the metronome sound.
<Note>
Metronome sound will be output from track 16.
For this reason, when the metronome function is activated, a new sound source cannot be recorded on the
track to which the metronome sound is to be output or sound recorded on this track cannot be played back.
If the metronome function is not to be used, be sure to reset it to "Off."
* Initial Setting
* Available setting
* The setting is applicable song by song.
* The setting can be saved or loaded as a part of the song data
* The setting is memorized even when the power is off.
* Make sure you choose the right program before setting this
mode.
1. Select "Click" in the menu selection display and press
the [ENTER/YES] key.
The currently set item ("Off" or "On") will flash ("Off" will
flash if in the initial state).
Setting the Metronome function ["Click"]
: "Off"
: "Off" or "On"
Flashing
Erasing of the Registered Tempo
1. Under the above "Confirmation display," select the tempo
map which is to be erased and press the [ENTER/YES]
key.
In the same way as before, tempo value will flash and
"DEL" will be shown aside it.
2. Press the [F FWD] key and select "DEL," then press the
[ENTER/YES] key.
The selected tempo map will be erased.
3. Upon completing registering, press the [EXIT/NO] key
(or [STOP] key) to exit from the SETUP mode.
<Note>
You cannot register the "001BAR 1
2. Select "On" or "Off" with the [JOG] dial and press the
[ENTER/YES] key.
The selected item will be setup.
On
Off (default)
3. Press the [EXIT/NO] key (or [STOP] key) to exit from the
SETUP mode.
136
=120."
Metronome sound will be output from
track 16.
Metronome sound will not be output.
Flashing