Table of Contents
Advertisement
The SETUP mode of the VF160EX offers the "Changing the initial settings" menus, which configure the operating
environment of the VF160EX, a "Check" menu that enables you to check the number of events for each track, and an
"Execution" menu that executes certain operations, such as save and load and disk formatting. The "Changing the
initial settings" menu include 21 parameters as shown in <Table-1> below. These parameters were set before the
VF160EX was shipped from the factory and these values are called the "initial settings." Modifying these settings allows
you to change the operating environment of the VF160EX. The "Check" menu provides two parameters "Checking the
number of events" as shown in <Table-2> - "Checking the number of events" and "Checking the current drive
information."
Also, as shown in <Table-3>, the "Execution" menus include five items: Title Edit, Delete PGM, Load PGM, Save PGM,
and Disk Format, which you can execute by selecting the corresponding SETUP menu. This chapter explains how to use
the "Changing the initial settings" menus shown in <Table-1> and the "Check" menu shown in <Table-2>.
For more information on the "Execution" menus, refer to the corresponding pages in the "Reference page" column in
<Table-3>.
Parameters
Setting a time signature
Setting a tempo
Setting the metronome function
Setting a preroll time
Setting MIDI sync output signal
Setting an MTC frame rate
Setting an MTC offset value
Setting the offset mode
Setting the slave mode
Setting the slave type
Setting the record protect function
Setting digital input
Setting digital output
Setting BAR/BEAT resolution mode
Setting the MIDI device ID number
Setting the fader fix mode
Setting the fader recall mode
Setting the pair fader
Setting the phantom power
Setting the compressor channel
Check item
Check of the event number on the track
Check of the current drive information
Execution item
Editing a program title
Deleting a program
Saving song data to an external device
Loading song data from an external device
Formatting an current drive disk
Chapter 7 SETUP mode
<Table-1> "Changing the initial settings" menu
Display
Signature Set
Tempo Set
Click
Preroll Time
Midi Sync Out
Frame Rate
Mtc Offset
Offset Mode
Slave Mode
Slave Type
Rec Protect
Digital In
Digital Out
Resolution
Device ID
Fader Fix
Fader Recall
Pair Fader Set
Phantom Power
Comp. Channel
: Modes applicable program by program. They can be saved/loaded.
: Modes applicable to all program. They cannot be saved/loaded.
• The above "Default setting" is the figure immediately after formatting the
current drive.
<Table-2> "Check" menu
Display
Number Of Event
Drive Information
<Table-3> "Execution" menu
Display
Title Edit
Delete
Load PGM
Save PGM
Disk Format
Default setting
001BAR 4/4
001BAR 1 120
00s
25 frame
Off
00
Off
Off
Off
Refer page
143
144
Refer page
71
71
106
106
23
132
Refer page
Community
133
135
136
137
137
138
138
139
139
140
140
141
142
142
143
145
145
146
147
148
Community
-
-
Community
-
-
-
-
-
Advertisement
Chapters
Table of Contents
