Fostex VF160EX Operation Manual page 98

2. Press the [EXIT/NO] key.
The chain play list is made and the "Chain Play List"
screen is dismissed. The display returns to the "Select
Menu" screen, where the current option of the "Chain
Play" menu item flashes (by default, "Off" flashes) and
you can now set the chain play mode.
For details about how to set the chain play mode, see
"Setting the chain play mode" on page 99.
<Note>
If a program which participates in the chain play list
is deleted from the drive(see "Deleting a program"
in the owner's manual), the whole play list is cleared
(it returns to show "C01: END").
If you select the "Delete" menu item of the Setup mode
and press the [ENTER/YES] key, the display shows the
warning message ("[ WARNING] Delete Play List
too?").
Making the chain play list by selecting desired
programs
The following procedure example shows how to enter
the five desired programs (from among 10 programs
on the current drive) to steps 1 through 5 in the chain
play list, as below.
: C01 -> program 5 (P05)
: C02 -> program 3 (P03)
: C03 -> program 1 (P01)
: C04 -> program 2 (P02)
: C05 -> program 4 (P04)
1. While "END" is flashing on the screen, rotate the [JOG]
dial to select "P05" and press the [ENTER/YES] key.
You can select the desired program by rotating the [JOG]
dial to the right.
When selecting the program, the first nine characters of
the program name is also shown (in the example below,
the name is "#0005").
After selecting "P05" and pressing the [ENTER/YES] key,
program 5 (P05) is set to step 1 (C01) of the chain play
list and the screen changes as shown below.
2. Use the [JOG] dial to highlight "C02: END" and press the
[ENTER/YES] key.
As with procedure step 1) above, "END" of "C02: END"
starts flashing.
3. While "END" is flashing on the screen, rotate the [JOG]
dial to select "P03" and press the [ENTER/YES] key.
As with procedure step 1) above, program 3 (P03) is set
to step 2 (C02) of the chain play list and the screen
changes as shown below.
Set programs to steps 3 through 5 (C03 through C05)
of the chain play list with the same manner as above.
4. After completing setting all the desired programs to the
chain play list, press the [EXIT/NO] key.
The chain play list is made and the "Chain Play List"
screen is dismissed.
The display returns to the "Select Menu" screen, where
the current option of the "Chain Play" menu item flashes
(by default, "Off" flashes) and you can now set the chain
play mode.
For details about how to set the chain play mode,
see "Setting the chain play mode" on page 99.
98