Fostex VF160EX Operation Manual page 127

<Notes for selecting more than one program>
When recording more than one program to a CD-
RW/CD-R disc, do not skip any track when assigning
programs to tracks.
If you skip any track, you cannot record data to the
subsequent tracks. In the following example, track
03 is skipped when assigning programs.
So only tracks 01 and 02 will be recorded. Tracks 03
and subsequent tracks can not be recorded.
<Note>
When making an audio CD, if you select a program
which consumes more disc space than the recordable
space of a CD-RW/CD-R disc, " Disk Full! " appears on
the display and you cannot select the program.
10. After specifying the program(s), press the [ENTER/YES]
key while holding down the [RECORD] key.
The VF160EX starts recording to the disc, while the
display shows the following screen.
When the recording ends, "Save Completed!" appears
on the screen, while the disc is automatically ejected
from the CD-R/RW drive.
11. When completed, press the [EXIT/NO] key (or [STOP]
key) to quit the Setup mode.
<Hint>
When a CD-RW disc on which any data is recorded is set,
if you perform step 7 above (i.e. pressing the [ENTER/
YES] key when "CD-DA" is flashing), "Not Empty!" appears
on the display, followed by the screen for selecting
whether erasing recorded data or ejecting the disc.
Flashing
• If you erase recorded data:
Press the [ENTER/YES] key while "ERASE" and "Sure?"
are flashing. After the key press, the display changes as
follows and the unit starts erasing the data. As the eras-
ing process is going on, the number of flashing "*" in-
creases.
Flashing
The number of flashing "*" increases.
When erasing is completed, the display shows the same
screen which appears when pressing the [ENTER/YES] key
after selecting "CD-DA" on step 7 above. So follow the
same procedure from step 8 on page 126.
<Note>
The erasure operation described above is the "quick
erasure". The VF160EX only erases special areas (TOC,
etc.) and does not read error after carrying out the
erasure operation above, try to carry out "full era-
sure" described on page 117.
• If you eject the disc:
Use the [JOG] dial to make "Eject" flashing and then
press the [ENTER/YES] key.
The disc is ejected, while "Insert Disk!" appears on the
screen.
When inserting a blank disc, you can go on the next
step (see the procedure described above).
127
Flashing
Flashing