Restarting The Docucolor - Xerox DocuColor 5750 User Manual

1
1-7 Starting and shutting down the DocuColor
When the diagnostics are finished, the following message is displayed:
For software update or setup press any key
If you want to change the Setup options, press one of the buttons; if you do not press a
button, the DocuColor continues starting up and displays the message
ready to receive data.
If you press a button, the following options appear:
Choose:
Run Setup
Install Software
Format Disk

Restarting the DocuColor

You should use the procedure described in this section to restart the DocuColor rather
than using the power switch on the rear of the DocuColor.
T D C
O RESTART THE OCU OLOR
1. Make sure that the DocuColor is not receiving, processing, or printing a document.
Make sure that the status message on the Control Panel is
If a job from the Print Queue is processing, it will continue processing and print
N :
OTE
after the DocuColor is restarted; if a job sent to the direct connection is processing, it
will not finish processing or printing.
2. Press the Menu button to display the Functions menu.
3. Use the down arrow button to scroll to the last screen and choose Reboot Server.
To do this:
View the options in the Setup menus. For information on
these settings, see the Administrator Guide.
Install new system software. This should be done only by
your DocuColor service representative.
Reformat the DocuColor hard disk. This should be done
only by your DocuColor service representative.
:
when it is
Idle
Idle .