Remote Connection; Power Connection - Extron electronics SW RGBHV Series User Manual

Remote connection

Remote connector — Connect a host device, such as a computer or touch
5
panel control, or a remote contact closure device to the switcher via this
9-pin D connector (figure 2-10) for remote control of the switcher.
See chapter 4, "Remote Control", for definitions of the SIS commands, details
on how to install and use the control software, and information on how to
construct a remote contact closure device.
5
9
Female
1
6
Male
Figure 2-10 — Remote port connector and pinout

Power connection

AC power connector — Plug a standard IEC power cord into this connector
6
to connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
Pin RS-232
1
1 —
2 TX
6
3 RX
4 —
5
5 Gnd
6 —
7 —
9
8 —
9 —
SW RGBHV Series Switchers • Installation
Contact closure Function
In #1 Input #1
— Transmit data (-)
—
Receive data (+)
In #2 Input #2
Gnd Signal ground
In #3 Input #3
In #4 Input #4
In #5 Input #5
In #6 Input #6
2-9