Table of Contents
Advertisement
Installation, cont'd
SW4 and SW6 models
1.
2.
#8 Screw (4 Plcs)
Each Side
Figure 2-2 — Mounting an SW4 or SW6 switcher in a rack or under
furniture
3.
4.
Under-furniture mounting the switcher
The SW2 switcher models can be mounted under a table or other horizontal surface
with an optional Extron under-desk mounting kit (part #70-077-01). The SW4 and
SW6 switcher models can be mounted under a table or other horizontal surface
with an optional Extron 1U under-desk mounting kit (part #70-222-01).
SW2 models
1.
2.
3.
4.
5.
6.
2-4
SW RGBHV Series Switchers • Installation
If rubber feet were installed on the bottom of the switcher, remove them.
Attach the rack mount brackets to the switcher with eight provided #8
machine screws, provided (figure 2-2).
Mounting Screws (2 Plcs)
Rack-mount
Bracket
or
Under
Furniture-mount
Bracket
Insert the switcher into the rack, aligning the holes in the mounting bracket
with those of the rack.
Secure the switcher to the rack using the supplied machine screws.
Secure the optional under-desk mounting brackets to the switcher with the six
machine screws provided in the mounting kit (figure 2-3).
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the mounting
surface.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
Slide the switcher slightly forward or back, then tighten all four screws to
fasten it in place.
Each Side
3
L
R
2
L
R
1
L
B
O U
G
T 5
V
P U
IN
V
R
H /H
B
G
T 6
R
P U
IN
T 3
V
P U
IN
V
H /H
B
G
T 4
R
P U
IN
T 1
V
P U
IN
V
H /H
B
G
1. 3A
0V
0- 24
10
T 2
R
P U
IN
z
-6 0H
50
Drill pilot holes
3/32" (2.4mm) dia.
1/4" (6.3 mm) deep.
U T
T P
O U
R
L
6
R
T E
M O
L
R E
R
5
L
TO
A U
T S
R
P U
4
IN
L
R
A L
N U
M A
V
H /
H V
U T
T P
Advertisement
Table of Contents
