Extron electronics SW RGBHV Series User Manual page 4

Quick Start — SW RGBHV Switchers
Installation
Step 1 — Remove power
Turn off power to the input and output devices,
and remove the power cords from them.
Step 2 — Mounting
SW2 —
If desired, mount the switcher in a rack using an
Extron 1U Universal Rack Shelf, part # 60-190-01 or
60-604-02.
If desired, mount the switcher under a desk using
an Extron Under-desk Mount Kit, part #70-077-01.
If desired, mount the switcher through a desk using
an Extron Through-desk Mount Kit, part #70-077-02.
SW4 or SW6 —
If desired, mount the switcher in a rack with the
supplied rack ears.
If desired, mount the switcher under a desk using
an Extron 1U Under-desk Mount Kit,
part #70-222-01.
Step 3 — Video Inputs
Connect up to 2, 4 or 6 RGBHV, RGBS, RGsB, or
RsGsBs video or component video inputs to the
Input connectors (3).
Step 4 — Video Output
Connect an RGBHV, RGBS, RGsB, or RsGsBs video
or component video display or other device to the
Output connectors (3).
3
RGBHV
G
RGBS
R G
RGsB,
RsGsBs,
Component
R G
Step 5 — Audio Inputs
Cable audio models for stereo audio input (5).
High impedance is generally over 10k ohms.
5
Step 6 — Audio Outputs
Cable audio models for stereo audio output (6).
6
Tip
See caution
Sleeve
Tip
See caution
Unbalanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Output
Step 7 — Remote Control
Connect a host device, such as a computer or touch
panel control via RS-232, OR connect a remote
contact closure device to the switcher via this
9-pin D connector (7) for remote control of the
switcher.
To command a switch under contact closure
control, momentarily short an input's pin on the
remote connector to ground (the switcher must be
in normal [manual] mode).
See chapter 4, "Remote Control", for definitions of
the SIS commands and details on how to install and
use the control software.
H/HV
B V
7
5
H/HV
V
B
1
H/HV
B V
Step 8 — Connect power
Plug the switcher, input devices, and output
devices into a grounded AC source, and turn on the
input and output devices.
SW RGBHV Series Switchers • Quick Start
Tip
Sleeve
Sleeve (s)
Tip
Sleeve
Unbalanced Input
(high impedance)
CAUTION
Pin RS-232 Contact
1
closure
1 — In #1
2 TX
9 6 3 RX
Female
4 — In #2
5 Gnd Gnd
5
6 — In #3
7 — In #4
8 — In #5
6 9
9 — In #6
Male
Tip
Ring
Tip
Ring
Balanced Input
(high impedance)
Connect the sleeve
to ground.
Connecting the
sleeve to a negative
(-) terminal will
damage the audio
output circuits.
Function
Input #1
— Transmit data (-)
—
Receive data (+)
Input #2
Signal ground
Input #3
Input #4
Input #5
Input #6
QS-1