Building And Uploading A Gc File; Step Eleven: Build The Global Configurator File - Extron electronics Extron IPL T S4 Setup Manual

12.
13.
14.

Building and Uploading a GC File

Before a Global Configuration (GC) file is active in the
GlobalViewer interface, the GC file must be "built" and
"uploaded" to a GlobalViewer host device.
The "build" process compiles all of the configuration data you
have entered into the GC file for each A/V network device.
The "upload" process delivers the built (compiled) file to the
GlobalViewer host device.
After the GC file has been uploaded to a host device, you can
launch the GlobalViewer interface by entering the host device's
IP address in the address field of an Internet browser.

Step eleven: build the Global Configurator file

There are two Build commands:
• Build All Configurations — compiles configuration data
for all devices in the GC file, including data for devices
previously uploaded to a GlobalViewer host device.
• Build Changed Configurations — compiles configuration
data only for devices that have been added or changed since
the previous Build cycle.
To initiate a "Build (all)" process:
1.
Click Next again to add an e-mail notification.
Select an e-mail message and contacts, and click
Apply Email/Contacts.
Click Done. The dialog box closes.
Click Build > Build All Configurations...
or click the Build All Configurations icon.
A Please Wait. Building Configuration(s)... dialog box
opens and displays a progress bar while the GC file is
being built.
IPL T S Series Interfaces • Software Setup 3-19