Section 3 - Handling And Storage; Lifting Weights; Delivery And Storage - York YMAA 0045 Installation Manual

FORM NO.: 6U6K-B01E-NB-EN
Rigging and lifting should only be done by a
professional rigger in accordance with a written
rigging and lifting plan. The most appropriate
rigging and lifting method will depend on job
specific factors, such as the rigging equipment
available and site needs. Therefore, a professional
rigger must determine the rigging and lifting method
to be used, and it is beyond the scope of this manual
to specify rigging and lifting details.

LIFTING WEIGHTS

Refer to the unit nameplate for unit shipping weight. Note that
weight may vary depending on unit configuration at the time of
lifting. Refer to the Physical Data tables within this manual for
further information regarding shipping and operating weights.
JOHNSON CONTROLS
Cooke Industries - Phone: +64 9 579 2185
SECTION 3 – HANDLING AND STORAGE
Email: sales@cookeindustries.co.nz
SECTION 2 – PRODUCT DESCRIPTION

DELIVERY AND STORAGE

To ensure consistent quality and maximum reliability, all units
are tested and inspected before leaving the factory. Units are
shipped completely assembled and containing refrigerant
under pressure. Units are shipped without export crating unless
crating has been specified on the Sales Order.
If the unit is to be put into storage, prior to installation, the
following precautions should be observed:
•
The unit must be "blocked" so that the base is not permitted
to sag or bow.
•
Ensure that all openings, such as water connections, are
securely capped.
•
Do not store where exposed to high ambient air temperatures
that may exceed relief valve settings.
Web: www.cookeindustries.co.nz
27