Edimax user guide Router User Manual page 41

Settings – Multi DMZ
Enable
Name
For Static IP
Public IP address
Private IP Address
(LAN)
For Dynamic IP
WAN
Session
Private IP Address
(LAN)
Access Group
Direction
Use this to enable or disable the DMZ setting, as required.
Enter a name to assist you to remember this setting. This name has no effect
on the operation.
Enter the WAN port (Internet) IP address you wish to associate to a PC. This
IP address must have been allocated to you by your ISP.
Enter the IP address of the PC you wish to associate with this WAN port IP
address. This IP address should be fixed, or reserved. (See the Host IP
section for details on reserving an IP address.)
Select the desired WAN port.
•
Select "DHCP" if the IP address on this WAN port is dynamically
assigned. You can only select assign one (1) Private (LAN) IP address to
each port.
•
If using multi-session PPPoE, select the desired PPPoE session. These
sessions are defined on the Advanced PPPoE screen. You can assign
one (1) one (1) Private (LAN) IP address to each PPPoE session.
Enter the IP address of the PC you wish to associate with this WAN port IP
address. This IP address should be fixed, or reserved. (See the Host IP
section for details on reserving an IP address.)
You can decide the users to have the authority of using DMZ, by define the
groups.
For DMZ, you can allow inbound, outbound only, or both inbound and
outbound both.
Page 37