Advanced Pppoe - Edimax user guide Router User Manual

Advanced PPPoE

The screen is required in order to use multiple PPPoE sessions on the same WAN port.
It can also be used to manually connect or disconnect a PPPoE session.
Settings – Advanced PPPoE
WAN Port
PPPoE Session
Session MTU
WAN IP Account
Action
Connection
Status
Figure 4: Advanced PPPoE
Select the desired Port and Session, then click the "Select" button. The data
for the selected Port/Session will then be displayed in the WAN IP Account
section.
The Maximum Transfer Unit for PPPoE packet data. Leave it as default,
unless the ISP offers different PPPoE packets data size.
•
User Name – Enter the PPPoE user name assigned by your ISP.
•
Password – Enter the PPPoE password assigned by your ISP.
•
Verify Password – Re-enter the PPPoE password assigned by your ISP.
•
IP Address – If you have a fixed IP address, enter if here. Otherwise, this
field should be left at 0.0.0.0.
•
Host Name – This field is used by a Host to uniquely associate an access
concentrator to a particular Host request.
Use the "Connect" and "Disconnect" buttons to establish or terminate a
connection on this session, if required.
This displays the current connection status for each session.
Page 23