Edimax user guide Router User Manual page 17

•
For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100)
should be ON.
3. Configuring The Load Balancer for Internet Access
Select Primary Setup from the menu, to see a screen like the example below.
•
Configure WAN 1 and/or WAN 2 as required.
•
For any of the following situations, refer to Chapter 3: Advanced Port Setup for any further
configuration, which may be required.
•
Using both ports
•
Multiple IP addresses on either port
•
Multiple PPPoE sessions
•
PPTP connection method
Figure 2-5: Primary Setup Screen
Page 13