Advertisement
6. After FPC insertion, do not apply an excessive load to the lever in the opening
direction beyond its open position; otherwise, the lever may be deformed or
removed
7. Do not apply an excessive load to the lever in a direction perpendicular to the
lever rotation axis or in the lever opening direction; otherwise, the terminals
may be deformed, and the lever may be removed.
8. When using FPC bending, please pay attention to precautions below;
otherwise, in some conditions it may cause conduction failure, connector breakage,
unlocking lever or FPC disconnection..
・Design so that a load is not applied to connector directly by FPC bending.
・Avoid sharp FPC bending at the root of FPC insertion part.
×
Sharp bend
・Design so that a load is not applied to the part of FPC bending
・If there might be a load on FPC, please fix the FPC
×
×
×
Panasonic Corporation
industrial.panasonic.com/ac/e/
Guide for Getting FPC connector Y5B and Y5BW
FPC
- 6 -
×
Sharp bend
×
×
×
×
©
Panasonic Corporation 2015
ACCTF15E-3
201507
Advertisement
