Advertisement
* After an FPC is inserted, do not pull the FPC
forcefully or do not apply an excessive load.
* When using FPC bending, please pay attention
to precautions below;
・Avoid sharp FPC bending at the root of FPC insertion part.
・Design so that a load is not applied to the part of FPC bending
・If there might be a load on FPC, please fix the FPC.
1.3 Remove the FPC at parallel with
the lever fully opened.
* Do not remove the FPC when
the lever is closing; otherwise,
the product may break or
cause a faulty connection.
* When opening the lever to remove
the FPC, ensure that the lever will
not go over the initial position;
otherwise, the lever may be deformed.
* Do not apply a load to the lever
unevenly, such as to an edge only,
when opening the lever of
large number of pins; otherwise,
the lever may be deformed
Panasonic Corporation
industrial.panasonic.com/ac/e/
Precautions after FPC insertion
1.3 Removing FPC
Precautions
Guide for Getting FPC connector Y5B and Y5BW
©
Panasonic Corporation 2015
- 9 -
ACCTF15E-3
201507
Advertisement
