Advertisement
07-5. Detailed precautions for manual soldering
(1) General precautions
-When applying flux, apply it thinly on each foot
pattern using a brush pen as shown on the
previous page.
(Place the connector at a predetermined
position after applying flux.)
-The use of a soldering iron with a retractable-
knife shape tip as shown in the previous page
is also recommended.
-While heating with the soldering iron, it is
recommended to slide the iron tip on the foot pattern
along the terminals without touching them.
-Apply the soldering iron to the foot pattern to heat it.
Complete soldering in 1 or 2 seconds.
Connector's resistance to soldering heat
- 300 °C: 5 sec max.
- 350 °C: 3 sec max.
- Thin wire solder with a diameter of 0.3 - 0.4 mm is recommended.
- Final soldering is recommended after provisionally soldering the terminals at
both ends.
- Note that when the soldering iron touches the terminal, wicking or contact
failure may occur.
(2) Detailed precautions on how to apply the iron tip
Place the iron tip on the end of the foot
pattern,
and apply heat to melt the solder.
Do not touch and push the terminal
with the iron tip, since the contact may
become deformed.
If the iron tip touches and pushes the
terminal end, the contact may also
become deformed.
This must also be avoided.
(3) Flux cleaning method
Pay attention to the following points when cleaning flux to prevent contact failures
due to the presence of flux:
- To prevent secondary contamination, clean flux using three-chamber cleaning
equipment because contamination of the cleaning agent can be controlled
Panasonic Corporation
industrial.panasonic.com/ac/e/
Guide for Getting FPC connector Y5B and Y5BW
The pattern length is recommended that
the iron tip does not touch the lead.
Soldering iron tip
©
Panasonic Corporation 2015
- 17 -
Solder wire
ACCTF15E-3
201507
Advertisement
