HoMedics BPA-960BT Manual page 25

4. After all symbols disappear, the display will show "00". The
monitor is "Ready to Measure" and will automatically inflate
the cuff to begin measurement.
5. When the measurement is completed, the cuff will deflate
entirely. Systolic pressure, diastolic pressure and pulse
will be shown simultaneously on the LCD screen. The
measurement is then automatically stored into memory.
Note:
• This monitor automatically returns to standby mode
approximately 60 seconds after last operation. You may also
press the START/STOP button to return to standby mode.
• To interrupt the measurement, you may press the START/
STOP button. The cuff will deflate immediately after a button
is pressed.
• If the cuff does not stop inflating, remove the cuff at
once.
24