HoMedics BPA-960BT Manual page 20

1. If the cuff is not assembled, pass the end of the cuff furthest
away from the tubing through the metal D-ring in order to form
a loop. The smooth side without the felt material should be on
the inside of the cuff loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert connector here
3. Open the arm cuff so that your arm may be placed through it.
4. Wrap the cuff on a bare arm or over thin clothing. Thick clothing
or a rolled up sleeve will cause inaccurate blood pressure
measurements
19