Steps
1. Place the touchpad into its slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
4. Connect the touchpad Flexible Flat cable to the connector on the system board and close the latch.
5. Place the touchpad bracket on the touchpad.
6. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
7. Replace the four (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the SSD.
5. Remove the
wireless
card.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
77