Setting Your Nbg To Ap Mode; Accessing The Web Configurator In Access Point Mode - ZyXEL Communications NBG6503 User Manual

8.3.1 Setting your NBG to AP Mode

Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on
1
how to do this.
To use your NBG as an access point, go to Maintenance > Sys OP Mode and select Access Point
2
mode.
Figure 45 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your NBG is already in Access Point mode.
When you select Access Point Mode, the following pop-up message window appears.
3
Figure 46 Pop up for Access Point mode
Click OK.
Click Apply. The Web Configurator refreshes once the change to Access Point mode is successful.
4

8.3.2 Accessing the Web Configurator in Access Point Mode

Log in to the Web Configurator in Access Point mode, do the following:
Connect your computer to the LAN port of the NBG.
1
The default IP address of the NBG is "192.168.1.2". In this case, your computer must have an IP
2
address in the range between "192.168.1.3" and "192.168.1.254".
Chapter 8 Access Point Mode
NBG6503 User's Guide
63