Fitting The Thermometer Sensor (If Supplied) - Viessmann Vitocell 100-E Installation And Service Instructions Manual

Installation
(cont.)

Fitting the thermometer sensor (if supplied)

Fig.4
1. Guide the thermometer sensor through the cover
strip and insert the thermometer.
2. Insert 3 of the thermometer sensors into the clamp-
ing bracket as far as they will go and tighten the
wing nut.
3. Pull the sensor retainer from the sensor well.
1.
2.
3.
4.
5.
6.
4. Position the sensor on the outside of the sensor
retainer contact spring so that it is flush with the
front of the spring.
Note
Never wrap insulating tape around the thermometer
sensor.
5. Secure the thermometer sensor lead.
6. Insert the sensor retainer.
Installation sequence
7