Fitting The Thermometer Sensor (If Available) - Viessmann VITOCELL 100-E Installation And Service Instructions Manual

Type SVPA 750/950 l: Fitting the thermal...

Fitting the thermometer sensor (if available)

2.
1.
Fig. 13
1. Guide the thermometer sensor through the cover
strip and insert the thermometer.
2. Guide the upper thermometer sensor through the
lifting eye. Fully insert the sensor into the clamping
bracket. Tighten the wing nut.
Note
The cover strip is held in its vertical position by the
straight capillaries. This is necessary for the rest of
the installation.
3. Route the thermometer sensor capillaries to the
back.
Note
Repeat the following steps for each of the thermom-
eters installed.
(cont.)
3.
5.
4.
6.
7.
4. Depending on where the sensor is to be fitted:
Secure the thermometer sensor in the clamping
bracket or pull the sensor retainer out of the sensor
well.
5. Secure the sensor to the outside of the sensor
retainer contact spring so that it is flush with the
front of the spring.
Note
Never wrap insulating tape around the thermometer
sensor.
6. Secure the thermometer sensor capillaries.
7. Insert the sensor retainer.
Installation sequence
17