Mitel 6867i User Manual page 73

Filter Key for the Executive's Phone
The Executive's phone requires that only one Filter key be configured. The Filter key's value
can either be left undefined or, it can be defined using the following values:
• Executive Call Filtering Activation FAC (e.g. "#61")
Used when the Deactivation FAC is in the same format as the Activation FAC but
sequentially one number above the Activation FAC. For example, if the key value is defined
as "#61" (the Activation FAC), the phone will automatically assume that the Deactivation
FAC is "#62" and will use that code to deactivate Executive Call Filtering.
• Executive Call Filtering Activation FAC followed by a semi-colon and then Executive Call
Filtering Deactivation FAC (e.g. "#61;*61" or "#61;#71")
Used when the Activation and Deactivation FACs are not in the same format or when they
are not sequential. For example, if the Activation FAC is configured in the Clearspan Web
portal is "#61" and the Deactivation FAC is configured as "*61" or "#71", the key value
should be defined with the two specific FACs separated by a semi-colon (i.e. "#61;*61" or
"#61;#71" respectively).
Notes:
1. If the Deactivation FAC is not specified after the semi-colon (e.g. "#61;"),
the phone ignores the semi-colon and behaves as if only the Activation FAC
was defined (i.e. the phone automatically assumes that the Deactivation
FAC is in the same format but sequentially one number above the Activation
FAC.
2. The IP phones support Executive Call Filtering Activation/Deactivation
FACs that contain the prefix "#" or "*".
Irrespective of a defined or undefined key value, when the Filter key is pressed, Executive Call
Filtering is activated and the key's corresponding LED is lit. When the Filter key is pressed
again, Executive Call Filtering deactivates and the key's corresponding LED turns off.
Note: Upon a reboot, the initial state of the Filter key LED will correspond to the Executive
Call Filtering state configured on the call manager.
Filter Key for the Assistant's Phone
As an Assistant can be associated with multiple Executives simultaneously, the Assistant's
phone can be configured with multiple Filter softkeys; one softkey for each Executive. In this
case, the value of each Filter softkey should correspond to the phone number or extension of
the respective Executive as per configured in the user's profile.
When Filter softkeys are configured with key values, pressing the respective Filter softkey
activates Executive Call Filtering for the applicable Executive and the softkey's corresponding
LED is lit. When the same Filter softkey is pressed again, Executive Call Filtering for the
applicable Executive deactivates and the softkey's corresponding LED turns off.
Alternatively, a single Filter softkey can be configured without a defined key value. If this is the
case, the Assistant is able to manually activate and deactivate Executive Call Filtering for each
IP Phone Keys
Mitel | 64