Brother ReChargX RX417XX Instructions Manual page 8

Wedge the tip of a flat-blade screwdriver between the

lip of the toner hopper opening and the toner hopper

plug. Then pry the plug up and out (Figure 8-8).

Note: TN starter plug will look different but the

removal process is the same.

Step 9: Remove the remaining Brother toner

Prior to adding "fresh" toner, we must remove the

residual "old" toner.

On the first refill of your Brother toner cartridge, the

new toner should not be combined with whatever

quantity of Brother toner remains in the hopper.

Failure to remove the remaining Brother toner will

result in splotching, smudging, hazing and other

print defects.

Note: This step does not need to be performed on

subsequent refills when fresh ReChargX™ toner

is being added to existing ReChargX™ toner.

Insert the toner hopper opening end of the cartridge

into the plastic zip-top bag which is included in the

ReChargX™ RX417XX toner refill kit (Figure 9-1).

Carefully pour out as much of the residual toner as

possible (tapping along the side of the cartridge helps

to keep the toner flowing) (Figure 9-2).

If the toner stops flowing, stand the cartridge upright

(with the toner hopper fill hole facing up) and then put

the end of the cartridge back into the bag and

continue the emptying process.

With the majority of the toner removed, remove the

cartridge from the bag. Seal the bag and discard it.

TonerRefillKits.com

9am - 5pm ET Mon - Fri

800.527.3712 or 352.343.7533

Figure 8-8: Removing the toner hopper plug

Figure 9-1: Inserting cartridge into zip-top bag

Figure 9-2: Dumping out the remaining Brother toner

ReChargX™ RX417XX

V1.0 - 2016.09.28

Page 8 of 14