Brother ReChargX RX417XX Instructions Manual page 3

Step 4: Prepare the cartridge for refilling

Position the cartridge on your work surface so the

handle (A) is facing toward you and the developer

roller (B) is facing away from you (Figure 4).

Step 5: Protect the developer roller

The developer roller (B) along the back of the

cartridge is critical to the image production process

and can be damaged even by a fingerprint.

To protect the roller during refilling we will cover it

with a sheet of paper.

Start with a piece of paper in "portrait" orientation,

then fold the 8.5" X 11" sheet in half (folding the

top edge over to meet the bottom edge) leaving an

8.5" X 5.5" sheet.

With the cartridge face up tape one of the long 8.5"

edges to the top of the cartridge (Figure 5-1).

Carefully fold the paper over the developer roller

(again, being careful not to touch the developer roller

with your fingers) and tape the other edge of the

paper to the bottom of the cartridge (Figure 5-2).

TonerRefillKits.com

9am - 5pm ET Mon - Fri

800.527.3712 or 352.343.7533

Figure 4: Cartridge separated from the drum unit

Figure 5-1: Protecting the developer roller (cartridge top)

Figure 5-2: Protecting the developer roller (cartridge bottom)

ReChargX™ RX417XX

V1.0 - 2016.09.28

Page 3 of 14