Chapter 1: Introduction; Revisions In This Manual - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E

Chapter 1: Introduction

This manual describes the RX3i IEC 60870-5-104 Option Parameters Ethernet Server
Module, IC695EIS001 (or EIS001 for short). By installing this module in the backplane of an
RX3i controller, the controller may be set up as an IEC 104 Server on an IEC 104 Network.
This permits RX3i data to be exchanged with the IEC 104 Clients on that network.
Introductory material may be found in this chapter. Chapter 2: provides installation and set-
up information. Chapter 3: provides configuration instructions. Chapter 4:describes system
operation. Chapter 5: provides diagnostic information. 0 covers the use and format of
ladder logic COMMREQ instructions used to set up and configure the EIS001 module and its
interaction with the IEC 104 Clients to which it is connected over Ethernet.
The appendices provide reference material for this application. Appendix D: Device Profile,
provides a profile of the IEC 104 Server.
1.1

Revisions in this Manual

Rev
E
D
C
B
A
-
Introduction
Date Description
Added Appendix E: Control Functions to explain usage of STARTDT,
Nov 2020
STOPDT, and TESTFR commands.
Following Emerson's acquisition of this product, changes have been
made to apply appropriate branding and registration of the product
Sep 2019
with required certification agencies. No changes to material, process,
form, fit or functionality.
The IEC-104 communication module IC695EIS001 firmware Release
1.40 provides enhancement to enable Report by Exception of analog
Jul-2017 data without time stamp through ASDU13 spontaneously instead of
ASDU36, this enhancement makes use of unused bit 10 of Option
parameter [67] as described in section Option Parameters.
The section, Specifications updated
The section, Parameters for Client Station-Server Connection updated
The section, Option Parameters updated table and added new
Mar-2016 subsections Multiple Client Connection Configuration and COMMREQ –
Shift RBE on Client Connection Associated with a Specified Port Number.
The section, Point Push for Digital Data removed.
The section, Point Push for Digital and Analog Datatable updated
Addition of support for Memory Translation Feature and Control Point
Apr-2015
Offset.
Dec-2014 Original Issue
Chapter 1
Dec 2020
1