Optional Configuration Parameters - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
• This type of configuration is not recommended.
Figure 24: Red/Write Interaction between Controller and IEC104 Client (Case 5)
• Communication between controller and IEC104 client with translation memory offsets
Note:
5.8

Optional Configuration Parameters

The parameters listed in Section 5.8are optional for RX3i IEC 104 Server configuration files.
The optional parameters are application-based, or user-defined, configuration parameters
that determine the Server functionality and the responses to Client station requests. All
configuration parameter values should be entered in decimal format. Refer to the
parameter description to determine valid input values for application-based, or user-
defined, parameter settings.
Note:
Configuration of IEC-104 Server Parameter
1. Point offset address is assigned with respective configured translation Offset + 1 to their
address.
2. CPO > Number of configured points will have the same effect as CPO = Number of configured
points: this configures all the points for Read / Write Operation.
3. Translation Offset address for Read and Command should not be equal for non-zero values.
4. Care should be taken during configuration of Read and Command Translation: do not allow
their respective offsets to overlap
Reserved parameters always have a value of zero (0).
Chapter 5
Dec 2020
40