Typical Fault Messages During Power-Up - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
EIS001 module continues to read data from the RX3i CPU memory, per its IEC 104 Server
configuration. Since no new data is available to be written to the CPU during the Ethernet
reset period, the EIS001 presents no new data to the RX3i CPU.
Disconnecting an RJ-45 connector from Port 1A or Port 1B will disrupt Ethernet traffic on the
corresponding port. The EIS001 continues to attempt transmission and reads data from the
RX3i memory per its IEC 104 Server configuration in order to have fresh data available for
transmission. Since no new IEC 104 data is received during this period, the EIS001 presents
no new data to the RX3i CPU. Once the RJ-45 connector is re-connected, data exchanges per
IEC 104 Server configuration will resume automatically.
5.4.1

Typical Fault Messages during Power-Up

The following messages may display in the RX3i CPU Fault Table during a typical power-on
sequence:
Figure 12: Typical Power-Up Controller Fault Table Entries Originated by EIS001
Typical Fault Messages during Power-Up details the normal start-up sequence of the EIS001
module. These annunciations are to be expected. In chronologic order, starting at the
bottom line and moving up, you will see:
a. The EIS001 is operating, and the check of the license has been performed. In this
b. The EIS001 firmware Revision is being displayed. In the example at value 4, C1 42 01
c.
d. The EIS001 module is not entering the main loop and has registered the module
Configuration of IEC-104 Server Parameter
example the module is licensed, starting in value 2 and 3, the different license checks
return in values 4 to 7 and in values 8 and 9 is D6 E6.
00, this is also the message before waiting for configuration.
The EIS001 module has been configured and is operating.
online.
Chapter 5
Dec 2020
29