Power-Up; Problems During Power-Up; Firmware Update Mode - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
LED
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
Port LEDs (one pair for Port 1A, second pair for Port 1B)
100 Mbps
LINK
5.3

Power-Up

5.3.1

Problems during Power-Up

Certain conditions can prevent the module from powering up and becoming operational or
entering firmware update mode:
Problem
Hardware failure
Invalid boot image
Invalid firmware
image
5.3.2

Firmware Update Mode

The EIS001 firmware consists of the ETM001 firmware plus the IEC 104 Server specific
firmware, and an Emerson installed license.
Each firmware upgrade may be obtained from the Emerson support web-site as a uniquely-
identified ZIP file. The ZIP file must be downloaded to a computer which can be connected
to the host RX3i CPU. Each ZIP file includes instructions specific to the target product.
The updated firmware may then be passed to the EIS001 through the host RX3i CPU using
the WinLoader utility. The CPU must be in STOP mode in order to deliver the firmware
upgrade through the Serial port on the CPU.
Figure 11: WinLoader Utility Screen-Shot
Configuration of IEC-104 Server Parameter
State
Blink error code
Off
Off
Slow Blink*
Slow Blink*
Slow Blink*
On
Off
Rapid Blink
Off
Indication
All Indicator LEDs off.
Module unresponsive.
Power LED is ON but OK LED is off
or Power LED alternates Green &
Amber
Indicates
Hardware failure, refer to
PACSystems RX7i & RX3i
TCP/IP Ethernet
Communications User Manual,
GFK-2224, section 12.4 for
blink code definitions.
(* All LEDs Firmware Update (pattern is
blink in the same for awaiting or
unison) performing load)
100 Mbps Active
100 Mbps Not Achieved
Traffic Detected on Port
No Traffic Detected on Port
Action
Contact Technical Support to
arrange for repair and replacement
Perform firmware update
Chapter 5
Dec 2020
27