Specifications - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
• Module can be installed in any available RX3i main rack I/O slot.
• Module supports insertion into and removal from an RX3i backplane which is under
power.
• Firmware upgrade through RX3i CPU using WinLoader software utility.
1.5

Specifications

Module Name
Catalogue
Protocol Supported
Connectors
LAN
Number of IP addresses
Number of Ethernet Ports
Embedded Ethernet
Switch
Serial Port
Modules per RX3i CPU
Number of 104 Clients
supported per module
Number of 104 Sectors
supported per module
Number of 104 Clients
supported per RX3i CPU
Number of 104 points per
module
Network Topology
supported
Hot Swappable
Time Synchronization
Power Requirements
For system standards, general operating specifications, and installation requirements, refer to
PACSystems RX3i System Manual, GFK-2314.
1
Two Protection objects (M_EP_TB_1 and M_EP_TC_1) are only accessible through Point Push and not as Controller points. This constitutes
2048 points (1024 each) and is included in the total number of Points per Module.
Introduction
PACSystems RX3i Ethernet 104 Server Module.
IC695EIS001-AA.
IEC60870-5-104 Server.
- Station Manager (RS-232) Port: 9-pin female D-connector
- Two 10BaseT / 100BaseTX Ports: 8-pin female shielded RJ-45.
IEEE 802.2 Logical Link Control Class I
IEEE 802.3 CSMA/CD Medium Access Control 10/100 Mbps.
One
Two. Both are 10BaseT / 100BaseTX with auto-sensing.
Connectors are RJ-45.
Yes – Allows daisy-chaining of Ethernet nodes.
Station Manager Port:
4
8
Refer to the sections Multiple Client Connection Configuration
and COMMREQ –Shift RBE on Client Connection Associated
with a Specified Port Number
One
4 per RX3i CPU
1
6144
Star, Line, Daisy Chain.
Yes
SNTP Client
3.3Vdc: 0.840 A maximum
5 Vdc: 0.614 A maximum.
RS-232 DCE, 1200 – 115,200 bps.
Chapter 1
Dec 2020
5