Station Manager Configuration - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
as documented in 0. Ranges should be selected to accommodate the amount of data
involved, but not overflow the end-point of the memory type.
The Server configuration file also includes parameters to define an area of Controller
memory for Client station-Server communication status, if required. The Parameters for
Server Status Space is defined in Section 6.4.3.
As mentioned above, the EIS001 may be connected to separate LANs using its two Ethernet
Ports (marked Port 1A and Port 1B). The two ports are independent and should be
connected to the same LAN. Whenever both ports are connected to active LANs, the Clients
on one LAN will typically impose different real-time demands on the EIS001 than the Clients
on the alternate LAN. Nonetheless, all traffic is handled per the Configuration of IEC 104
Server Parameters Using COMMREQ instruction detailed in 0.
3.7

Station Manager Configuration

Use the RS-232 Port (Station Manager) tab in PAC Machine Edition to set up the Station
Manager port on the EIS001 module.
Figure 10: Station Manager Configuration Tab (Showing Defaults)
Refer to PACSystems TCP/IP Ethernet Communications Station Manager User Manual, GFK-
2225.
Details on the EIS001-specific Station Manager commands may be found in Appendix B:. For
all common Station Manager commands, use ETM001 as a reference and refer to
PACSystems TCP/IP Ethernet Communications Station Manager User Manual (GFK-2225).
The EIS001 module is constructed on the ETM001 platform.
Configuration
Chapter 3
Dec 2020
22