JVC XV-M565BK Service Manual page 9

Removing the Video board
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the card wire from connector CN601 on
the video board (The card wire is extending from the
DVD changer mechanism assembly).
2. Disconnect the harness from connector CN704 on
the system control board (The harness is extending
from the video board).
3. Remove the three screws D
board on the rear panel. Pull out the video board
from the rear panel.
Removing the System control board
Prior to performing the following procedure, remove
the top cover.
The audio board can be removed even if the video
board is attached.
1. Disconnect the card wire from connector CN703 on
the system control board (The card wire is extending
from the front panel assembly).
2. Disconnect the card wire from connector CN701 and
CN702 on the audio board (The card wires are
extending from the DVD changer mechanism
assembly).
3. Disconnect the harness from connector CN704 on
the system control board (The harness is extending
from the video board).
4. Disconnect the harness from connector CN951 and
CN952 on the power supply board (The harness is
extending from the system control board).
5. Remove the screw H attaching the system control
board.
6. Remove the five screws D
control board on the rear panel. Pull out the system
control board toward the front.
(See Fig.11 and 12)
attaching the video
(See Fig.13 and 14)
attaching the system
Rear panel
Shield case
Front panel assembly
Fig.11
D
Fig.12
Power supply board
CN951
CN952
Shield case
Front panel assembly
Fig.13
D
Fig.14
XV-M565BK/M567GD
CN601
Video board
CN704
System
control
board
Rear panel
Rear panel
Video board
CN704
System
control
board
CN703 CN702
Rear panel
CN701
H
1-9