JVC XV-M565BK Service Manual page 18

XV-M565BK/M567GD
<Traverse mechanism section>
Removing the pickup unit
1. Make sure to solder the flexible harness.(In case of
replacement with a new product, unsolder the
flexible harness after performing the following
procedure.)
2. Disconnect the flexible harness from connector
CN12 on the connection board.
3. The rack cover is attached to the feed drive shaft.
Remove the two screws A attaching the connection
board and stand the connection board. Remove the
rack cover.
4. Remove the screw B
holder. Remove the pickup shaft holder by releasing
ATTENTION: Be careful not to lose the inside spring.
5. Pull out the shaft in the direction of the arrow and
slightly lift it with the pickup unit. Then, remove the
pickup unit while pulling the rack a in the direction of
the arrow.
1-18
(See Fig.1 to 3)
attaching the pickup shaft
A
Connection board
A
CN12
CN12
Fig.1
Feed drive shaft
Fig.2
Pickup shaft holder
Pickup unit
Shaft
Rack a
Fig.3
Flexible harness
Soldering
(Short circuit round)
Rack cover
Connection board
Tab
B
Tab