JVC XV-M565BK Service Manual page 7

Fig.5
Removing the Rear panel (See Fig.6)
Prior to performing the following procedure, remove
the top cover.
1. Remove the eleven screws D
panel on the back of the body and detach the rear
panel.
Removing the DVD changer mechanism assembly
Prior to performing the following procedure, remove
the top cover.
The DVD changer mechanism assembly can be
removed even if the front panel assembly is
attached.
1. Remove the four screws E
changer mechanism assembly cover and detach the
shield case at an angle.
2. Disconnect the 9pin harness from connector CN961
on the power supply board.
3. Disconnect the card wire from connector CN601 on
the video board.
4. Disconnect the card wires from connector CN701
and CN702 on the system control board.
5. Remove the four screws F
changer mechanism assembly. Pull up the DVD
changer mechanism assembly at an angle from the
front panel assembly.
Front panel assembly
Joints b
attaching the rear
(See Fig.7 and 8)
attaching the DVD
Power supply board
CN961
attaching the DVD
Fig.4
D
D
Fig.6
E
Shield case
E
Fig.7
DVD changer mechanism assembly
F
F
Fig.8
XV-M565BK/M567GD
Rear panel
D
E
E
Video board
F
CN601
CN701
System control
board
CN702
F
1-7