JVC XV-M565BK Service Manual page 33

Integrated wiring for adjustment
1. Place a board on top of the unit and put the
changer on it. Then carry out the wiring of the
main unit.
2. Connect the two extension cables (two types)
to the traverse mechanism for adjustment and
then connect them to the changer.
3. Remove the solder of the short-circuited
flexible wire. Then remove the short-circuited
pin from the traverse mechanism
4. Connection is completed.
Adjustment preparation
1. The 3 adjustment locations
2. 1.4 mm hexagonal wrench
3. Set the VT-501 or the VT502 test disc.
FL jitter display
1. Connect the power cable while pressing the
(OPEN/CLOSE) button of DISC1 and
(PLAY) button simultaneously.
--- The DISC no. "
the FL indicator.
2. Press the 3D-PHONIC button on the front
panel to commence initialization.
THEATER button
3D PHONIC button
3. Then by pressing the THEATER POSITION
button.
--- The DISC will start to rotate and
automatic adjustment is executed.
4. When the key (PLAY) is pressed the jitter
value is displayed.
5. Adjust the jitter value to minimum by using the
adjust screw.
" is displayed on
FL indicator
Extension cord
QUQ110-1122AJ
Wiring adjustment diagram
Adjustment location
(Adjust screw)
Adjustment location diagram
Jig ass'y clamp adjustment
XV-M565BK/M567GD
Extension cord
QUQ110-1013AJ
Hexagonal wrench
Adjustment location
(Adjust screw)
Test disc
3 locations
for adjustment
Adjust by using
a hexagonal
wrench
1-33