Table of Contents
Advertisement
Point remote control
5
from a distance of
#
1 cm to 8 cm towards button 1,
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
4
lights up green contin‐
R
uously. Programming is complete.
Indicator lamp
4
flashes green. Pro‐
R
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
If indicator lamp
4
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects
R
2
or 3.
are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or
3
repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
%
Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control
5
is supported.
Replace the batteries in remote control 5.
#
Hold remote control
#
from a distance of 1 cm to 8 cm front of the
inside rearview mirror. You should test every
position for at least 25 seconds before trying
another position.
Internal use only
#
#
2
#
%
Opening or closing the garage door
Requirements:
5
at various angles
R
#
Driving and parking 181
Hold remote control
5
at the same angles
at various distances in front of the inside rear
view mirror. You should test every position
for at least 25 seconds before trying another
position.
On remote controls that transmit only for a
limited period, press button
6
control
5
again before transmission ends.
Align the aerial line of the door opener unit
with the remote control.
Support and additional information on pro‐
gramming:
®
On the HomeLink
Hotline on (0) 08000
R
466 354 65 or +49 (0) 6838 907-277
On the Internet at https://
R
www.homelink.com
The corresponding button is programmed to
operate the door.
Press and hold buttons 1,
2
the door opens or closes.
on remote
or
3
until
Advertisement
Table of Contents
