Mercedes-Benz C-Class-Saloon 2020 Owner's Manual page 172

Hide thumbs Also See for C-Class-Saloon 2020:
Table of Contents

Advertisement

release the brake pedal.
#
switch the ignition off.
#
%
If you then exit the vehicle leaving the key in
the vehicle, the automatic transmission
remains in neutral i.
Engaging park position P
Observe the notes on parking the vehicle
#
(
page 178).
/
Depress the brake pedal until the vehicle
#
comes to a standstill.
When the vehicle is at a standstill, press but‐
#
ton j.
When the transmission position display
shows j, the park position is engaged. If no
transmission position display j appears,
secure the vehicle to prevent it from rolling
away.
%
Depending on the situation, it may take a
short time until j is engaged. Therefore,
always pay attention to the transmission
position display.
Park position j is engaged automatically if one
of the following conditions is met:
you switch off the ignition when the vehicle
R
is stationary and the transmission position is
h or k.
you open the driver's door when the vehicle
R
is at a standstill or when driving at a very low
speed and the transmission position is h or
k.
%
To manoeuvre with an open driver's door,
open the driver's door while at a standstill
and engage transmission position h or k
again.
Engaging drive position D
Depress the brake pedal and push the
#
DIRECT SELECT lever down past the first
point of resistance.
When the automatic transmission is in transmis‐
sion position h, it shifts the gears automati‐
cally. This depends, among other things, on the
following factors:
the selected drive program
R
the position of the accelerator pedal
R
Internal use only
Driving and parking 169
the driving speed
R
Problems with the transmission
The transmission has a faulty gear shift
Possible cause:
the transmission is losing oil.
R
Have the transmission checked at a qualified
#
specialist workshop immediately.
The acceleration characteristics get worse,
and the transmission no longer shifts.
Possible cause:
the transmission is in emergency operation
R
mode: it is only possible to shift to one gear
and reverse gear.
Stop the vehicle in accordance with the traf‐
#
fic conditions.
Shift the transmission to position j.
#
Switch off the engine.
#
Wait at least ten seconds.
#
Try to start the engine again.
#

Advertisement

Table of Contents
loading

Table of Contents