Table of Contents
Advertisement
Press the u and ^ buttons simultane‐
#
ously.
The Î symbol on the remote control display
will flash.
Use the , and . buttons to set the
#
desired departure time.
Press the u and ^ buttons simultane‐
#
ously.
The new departure time will be stored.
Up to three departure times can be stored.
To activate the departure time: select the
#
desired departure time and press and hold
the u button.
The Í symbol, the departure time and,
depending on the selected departure time,
the letter A, B or C will appear on the display.
To deactivate the departure time: select
#
the desired departure time and press and
hold the ^ button.
OFF will appear on the display.
To check the status of the active station‐
#
ary heater: briefly press the u button.
Switching off immediately
Press and hold the ^ button.
#
Overview of the remote control displays (sta‐
tionary heater/ventilation)
1
Stationary ventilation switched on
2
Stationary heater switched on
3
Selected departure time
4
Remaining time for the stationary heater/
ventilation (in minutes)
5
Stationary heater/ventilation active
6
Departure time activated
7
Signal strength
Internal use only
Climate control 151
Further possible displays:
Time: the activated departure time.
R
Zero minutes: the running time for the sta‐
R
tionary heater is extended because the
engine has not yet reached operating tem‐
perature when it is started.
OFF: the stationary heater/ventilation is
R
switched off.
Replacing the remote control battery (sta‐
tionary heater)
& DANGER Serious damage to health
caused by swallowing batteries
Batteries contain toxic and corrosive sub‐
stances. Swallowing batteries may cause
serious damage to health.
There is a risk of fatal injury.
Keep batteries out of the reach of chil‐
#
dren.
If batteries are swallowed, seek medical
#
attention immediately.
Advertisement
Table of Contents
