Specifications - Toro MB-1600 Operator's Manual

Engine Controls
Oil Alert System
The oil alert system is designed to prevent engine damage
caused by an insufficient amount of oil in the crankcase.
Before the oil level in the crankcase can fall below a safe limit,
the oil alert system will automatically stop the engine (the
engine switch will remain in the On position). If the engine
stops and will not restart, check the engine oil level before
troubleshooting in other areas
Choke Lever
The choke lever (Figure 5) is required when starting a cold
engine. Before pulling on the recoil start handle, move
the choke lever to the closed position. Once the engine is
running, move the choke lever to the open position. Do
not use the choke if the engine is already warmed up or the
air temperature is high.
4
3
2
1
1. Recoil starter
2. Fuel shut-off valve
3. Choke lever
Throttle Lever
The throttle lever (Figure 5) controls the speed (rpm) of the
engine. It is located next to the choke lever. It sets the engine
rpm and therefore can increase and decrease the speed of
the machine. For best performance, set the throttle lever to
the fast position.
Figure 5
4. Throttle lever
5. On/Off switch
Fuel-shutoff Valve
The fuel-shut off valve (Figure 5) is located underneath the
choke lever. Move the shutoff valve must to the On position
before attempting to start the engine. Once you have finished
using the machine and you have turned the engine off, move
the fuel-shutoff valve to the Off position.
On/Off Switch
The On/Off switch (Figure 5) allows the engine to start and
also stops the engine. This switch is located on the front of
the engine. The On/Off switch is marked as follows:
•
l (On)—the ignition system is On and the fuel flow
through the switch is turned On.
•
O (Off)—the ignition system is Off and the fuel flow
through the switch is turned Off.
Note: To start the machine, you must first move this control
to the On position. When you want to stop the engine, move
this switch to the Off position.
5
Recoil Starter Handle
To start the engine, pull on the recoil starter handle (Figure 5)
quickly to turn the engine over. The engine controls described
in Figure 5 must all be set correctly for the engine to start.

Specifications

Note: Specifications and design are subject to change
without notice.
Width (single wheel)
Width (double wheel)
G020538
Length
Height
Weight
Hopper capacity
Maximum load
Maximum load (single
wheel)
Wheelbase
Discharge Height
10
86 cm (34 inches)
117 cm (46 inches)
268 cm (105.5 inches)
114.3 cm (45 inches)
621 kg (1370 lb)
.45 m 3 (16 cu.ft.)
1136 kg (2500 lb)
850 kg (1875 lb)
107 cm (42 inches)
16.5 cm (6.5 inches)