Lubrication; Greasing The Machine; Engine Maintenance; Servicing The Air Cleaner - Toro MB-1600 Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Every 50 hours—Grease and oil the
machine.
Yearly—Pack wheel bearings.
If you operate the machine under normal conditions, lubricate
all grease fittings for the bearings and bushings after every 50
hours of operation with No. 2 general purpose lithium-base
grease. Lubricate bearings and bushings immediately after
every washing, regardless of the interval listed. Also, apply a
light coating of oil onto the control cables.
The grease fitting locations and quantities are as follows:
Note: Remove the blue protection caps before greasing and
replace when finished.
•
Hopper pivot points (Quantity 2)—Figure 19
g019607
Figure 19
•
Cylinder pivots (Quantity 2)—Figure 20
Figure 20

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Every 50 hours—Clean the air cleaner.
1. Wing nut
2. Air-cleaner cover
3. Wing nut
g019608
20
Every 300 hours—Replace the paper element.
1. Make sure that the wire is off the spark plug.
2. Remove wing nut securing air-cleaner cover to air
cleaner and remove cover. Clean cover thoroughly
(Figure 21).
3. Remove the wing nut from the air filter, and remove
the filter (Figure 21).
1
2
3
4
5
6
Figure 21
4. Remove the foam filter from the paper filter (Figure
21).
5. Inspect both air-filter elements, and replace them if
they are damaged.
Note: Always replace the paper air-filter element at
the scheduled interval.
G018671
4. Paper element
5. Foam element
6. Gasket