Table of Contents
Advertisement
Choke Lever
The choke lever (Figure 9) is required when starting a cold
engine. Before pulling on the recoil-start handle, move
the choke lever to the closed position. Once the engine is
running, move the choke lever to the open position. Do
not use the choke if the engine is already warmed up or the
air temperature is high.
Throttle Lever
The throttle lever (Figure 9) controls the speed (rpm) of the
engine. It is located next to the choke lever.
Recoil-start Handle
To start the engine, pull the recoil-start handle (Figure 8)
quickly to turn the engine over. The engine controls described
above must all be set correctly for the engine to start.
Oil-level Switch
The oil-level switch is located inside the engine, and it will
not allow the engine to run when oil level is below the safe
operating limit.
Specifications
Note: Specifications and design are subject to change without notice.
Width (without spreaders and screed
board)
Length
Height (without screed board)
Weight (without screed board)
Screed board thickness and height
Maximum screed board width
Model 68052
89 cm (35 inch)
56 cm (22 inch)
122 cm (48 inch)
53 kg (116 lb)
5 cm x 15–20 cm (2 inch x 6–8 inch) 5 cm x 15–20 cm (2 inch x 6–8 inch)
457 cm (15 ft)
9
Engine On/Off Switch
The On/Off switch (Figure 10) allows the operator of the
machine to start and stop the engine. This switch is located
on the front of the engine. It is marked l (On) and O (Off).
Rotate the On/Off switch to the On position to start and run
the engine. Rotate the On/Off switch to the Off position to
stop the engine.
1
Figure 10
1. Engine On/Off switch
Model 68053
89 cm (35 inch)
56 cm (22 inch)
122 cm (48 inch)
61 kg (134 lb)
914 cm (30 ft)
OFF
g018808
Advertisement
Table of Contents
