Table of Contents
Advertisement
Specifications
Note: Specifications and design subject to change without notice.
General Specifications
Cutting Capacity
Main Frame Construction
Trailer Tongue
Control Tower
Wing Lift Arms
Axle Assembly
Trailer Transport Wheels
Lifting Mechanism
Hydraulic Valve
Hydraulic Cylinders
Hydraulic Hoses
Hydraulic System
Couplers
Hydraulic System
Capacity
Jack
Safety/Transport Lockup
Devices
6.7 acres per hour @ 5.5 MPH. (Assumes no reduction in total area mowed due to
overlap, turning, stops, etc.)
Tubular and structural steel, bolted and electrically welded construction.
Tubular and structural steel welded construction. Trailer clevis is adjustable to 3
positions. Trailer tongue can be removed from frame for storage and shipping
purposes.
Adjustable 12–1/2" fore and aft and 7" up and down. Controls are operable from
tractor seat. Control tower is mounted on trailer tongue.
Tubular steel, reinforced welded construction.
Implement type. Max. load capacity = 4940 lbs.* Axle capacity= 6000 lbs. Hub
capacity = 3560 lbs. each Wheel capacity = 3000 lbs. each Tire capacity = 2470
lbs. each @ 28 psi.*Max. load capacity determined by tire capacity at maximum
inflation pressure of 28 psi.
Two 6 bolt, 6" bolt circle, 4.62" pilot, 15 x 8LB implement style wheels with 11 L–15
(low profile), 6 ply rating implement rib tires; 24–28 psi recommended tire pressure.
Hydraulic lift–1st, 2nd and 3rd cutting units operate together. Cutting units 4 and 5
operate individually. Units can be raised or lowered in any sequence on level
ground.
Heavy duty, directional control valve, parallel circuit, open center, stack design.
Cast iron valve bodies, with hardened spools and plated for corrosion protection.
Primary relief valve (1500 + 150 psi), shim adjustable. Relief valve prevents excess
pressure build–up in the hydraulic system and safeguards the hydraulic pump and
hoses. Closed center conversion kit available for use with tow tractors containing
closed center hydraulic systems.
Tie rod construction. 3" bore, double–acting cylinders; chrome–plated rods 1–1/8"
diameter (1–3/8" diameter on No. 1 cylinder), precision finished bore in cylinder
tubes.
SAE 100R7, one–wire braid, 1/2" I.D. feed line hoses from tractor to valve body.
SAE 100R7, 5/16" I.D. cylinder hoses from valve body to hydraulic cylinders
Quick disconnect couplers for easy hook–up to tractor.
Two gallons Mobilfluid 424 multifunctional transmission/hydraulic fluid with cylinders
retracted.
Side–screw type trailer jack. 10" stroke. Stores inside trailer tongue when not in
use. Load capacity 2200 lbs.
Safety strap provided to prevent accidental lowering of No. 4 & 5 cutting units
during transport. A safety lock–up pin prevents accidental lowering or settling of No.
1, 2, 3 cutting units during transport or storage. All lockup devices store on the
transport frame.
6
Advertisement
Table of Contents
