Printing Halts During Print Job - Canon W2200 User Manual

Printing Halts During Print Job

Error message is displayed.
Problem 1: An error message is displayed during printing.
Solution:
Problem 2: The selected Media Size is not correct for the media loaded in the paper
Solution:
Problem 3: Bi-directional communication between the printer and computer cannot
Solution:
Blank paper ejected from the printer.
Problem 1: A blank page is ejected from the previous print job.
Solution:
Problem 2: Printhead nozzles are clogged.
Solution:
Problem 3: Printer is damaged.
Solution:
Problem 4: Ink filling is not completed.
Solution:
7-8
Troubleshooting
Check if the error message appears in GARO Status Monitor for Windows
or GARO Printmonitor for Macintosh and follow the instructions in the
message to solve the problem. (ÆP.7-16)
supply source.
Confirm the current selection for the Media Size. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. (ÆP.2-8)
execute when the printer is connected via the parallel port.
Open the Setup Menu on the printer operation panel, select "Set
Centronics" Interactive then select "None". (ÆP.5-13)
The print job starts after the blank page is ejected.
Print a nozzle check pattern, check the condition of the printhead nozzles,
If you determine that the printhead nozzles are clogged, clean the
printhead. (ÆP.7-28)
Call for service.
If you don't see any ink in the ink hose, check the ink left in the ink tanks
to make sure that more than 40% of the ink is left, and then perform Head
Cleaning C. (ÆP.7-28) When there is little ink remaining, replace the ink
tank with a new tank, and then perform printhead cleaning. (ÆP.6-2)