Printing Halts During Print Job - Canon N1000 User Manual

Problem 7: An ink tank has run out of ink or the nozzles of the printhead are clogged.
Solution:

Printing Halts During Print Job

Error message is displayed.
Problem 1: An error message is displayed during printing.
Solution:
Problem 2: The selected Media Size is not correct for the media loaded in the paper
Solution:
Problem 3: Bi-directional communication between the printer and computer cannot
Solution:
Blank paper is ejected from the printer.
Problem 1: A blank page is ejected from the previous print job.
Solution:
Problem 2: Printhead nozzles are clogged.
Solution:
Problem 3: Printer is damaged.
Solution:
6-6
Troubleshooting
lever is down. ( P.2-15)
Print a nozzle check pattern to confirm the ink supply and condition of the
printhead.
If an ink tank has run out of ink, replace the ink tank. ( P.5-2)
If you determine that the nozzles are clogged, clean the printhead. ( P.6-
23)
Read the message displayed in the NetSpot and correct the problem
indicated by the error message. ( P.6-11)
supply source.
Confirm the current selection for the Media Size. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. ( P.2-7)
execute when the printer is connected via the parallel port.
Open the Setup Menu on the printer operation panel, select Set Centronics
Interactive then select None. ( P.4-9)
The print job starts after the blank page is ejected.
Print a nozzle check pattern, check the condition of the printhead nozzles,
If you determine that the printhead nozzles are clogged, clean the
printhead. ( P.6-23)
Call for service.