Canon W2200 User Manual page 108

Edges smeared with ink.
Problem 1: The selected Media Size is not correct for the media loaded in the paper
Solution:
Problem 2: Print media is curled or creased.
Solution:
Problem 3: Platen is stained.
Solution:
White or Dark Streaks Visible.
Problem 1: Printhead is out of alignment.
Solution:
Problem 2: The amount of paper feed from the paper cassette is incorrect.
Solution:
Solution:
Problem 3: The types of the media loaded in the cassette and the type of the media
Solution:
7-10
Troubleshooting
supply source.
Confirm the current selection for the Media Size. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. (ÆP.2-8)
Remove the creasing or curling then start the print job again.
Load more than 2 sheets wider than the smeared media, then perform
"Feed/Exit" on the operation panel.(ÆP.5-14)
When printing on plain paper, use the printer operation panel to perform
band adjustment with the "Band Adjust" item. (ÆP.7-34)
If the media loaded in the cassette is plain paper, follow the procedure
below.
1. On the operation panel, perform "LF Adjust" to print the line feed setting
pattern. (ÆP.7-37)
2. If the line feed setting pattern is printed with streaks, perform "Paper Adjust"
for each type of the media on the operation panel. (ÆP.7-40)
3. If the printer still prints streaks after performing "Paper Adjust", perform
"Band Adjust" on the operation panel. (ÆP.7-34)
If the media loaded in the cassette is not plain paper, perform "LF Adjust"
on the operation panel. (ÆP.7-37) If "LF Adjust" does not solve the
problem, perform "Paper Adjust" on the operation panel.
selected for Paper Adjust do not match.
Select correct setting for "Paper Adjust". (ÆP.7-40 )