Table of Contents
Advertisement
9
Care and maintenance
9
Servicing and maintenance intervals
.01
Clean the hook compartment ...............................Daily, several times if in continuous use
Check the oil level ........................................................... Daily, before starting the machine
Check/adjust the air pressure ......................................... Daily, before starting the machine
Clean the fi lter of the air fi lter/lubricator ........................................................... As required
9
Cleaning the machine
.02
The cleaning cycle required for the machine depends on following factors:
●
Single or several shift operation
●
Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
Fig. 9 - 01
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated more than this, shorter inter-
vals are recommended.
For all cleaning work the machine must be disconnected from the mains
by switching off the on/off switch or by removing the mains plug!
Danger of injury if the machine suddenly starts up .
Care and maintenance
To avoid breakdowns, the following cleaning
work is recommended for single shift ope-
ration:
●
Open the bed slide and remove the bob-
bin.
●
Clean the hook and hook compartment
daily, several times if in continuous use.
●
Set the bobbin in position and close the
bed slide.
33
Advertisement
Table of Contents
