Lap Belt Installation - Britax Poplar Canadian User Manual

Lap Belt Installation

IMPORTANT:
your vehicle owner's manual.
Attach the
1.
ReboundReduce
stability bar.
2. Recline the unoccupied
child restraint to
appropriate position
(see page 17-18).
3. Place child restraint
rear-facing on the
vehicle seat so that
the car seat base is
flat and parallel to the
vehicle seat.
NOTE: Ensure that no
more than 7.5 cm (3 in)
of the base hangs over
the edge of the vehicle
seat (see page 12).
4. Open the ClickTight.
a. Lift the front cover
flap.
b. Squeeze the
ClickTight release
buttons.
5. Slide the lap vehicle
belt into the rear-
facing belt paths.
6. Buckle the vehicle belt.
NOTE: Ensure the
vehicle belt is not
twisted.
26
Vehicle belt MUST be locked according to
TM
1
2
3
4
b
5
6
7.5 cm
a